Electronic Project

LED Flasher

5 Pattern Blinking




Penerangan Litar

Projek LED Flasher ini menggunakan program PIC (PIC16F84A) sebagai microcontroller.
Program PIC ini mengawal kelipan untuk 8 LED.
Pattern kelipan LED dikawal oleh 5 suis yang berbeza.



Binary to Decimal Converter



Circuit Operation


The decimal value of the eight input lines is displayed on three seven segment displays. Although chips exist to perform this function for single displays, none include the possibility of displaying numbers greater than 9. No EPROM is necessary in this design. It operates by using two synchronized counters, one that generates an 8-bit binary output, and a second that drives the display. If the display is updated only when the binary counter is at the same value as the input, then the display will show thw decimal value of the input. IC4 is the binary counter, and IC6 to IC8 form the display/counter section. IC5a and IC5b form the astable, which clocks both counters at 5 kHz. The minimun display refresh rate is, therefore, 20 times per second, IC1 and IC2 are two 4-bit comparators, ganged to form an 8-bit comparator. This compares the output of the binary counter (IC4) with the binary input taken from the circuit under test. Resistors R1 to R8 pull down the input lines to prevent them from floating when no input is connected. When the comparators inputs are equal, pin 6 of IC2 goes high, triggering the monostable (IC3ab), which outputs a brief pulse. This latches the value of the display counters (IC6 to IC8) to the dispaly. When IC4 reaches a value of 256, the link between pins 11 and 12 resets the chip, and this resets the display counter also.



Smart Parking


Circuit Sensor Infra-Red, Counter Up and Down, Parking Alarm



Circuit Motor Forward Reverse


PARKING WARNING SYSTEM

Assalamualaikum dan salam sejahtera..




Terima kasih kerana mengunjungi blog ini. Hari ini sempat juga saya upload gambar ProjekParking Warning System dan gambar Litar. Saya tahu ramai yang ternanti-nanti bagaimana projek ini berfungsi.
Bagaimana litar ini berfungsi?
Disini saya terangkan serba ringkas tentang fungsi litar ini. Litar ini menggunakan Infra-red untuk mengesan halangan yang berada dihadapan. Kelebihan litar ini ialah kita boleh set masa bila sensor mengesan.
Di manakah litar ini selalu di gunakan? Sebenarnya kegunaan litar ini adalah bergantung kepada kreativiti seseorang tersebut. Buat masa ini penggunaan litar ini ialah untuk tempat letak kereta (Parking Lot) dan tong sampah automatik.
Jika anda ada sebarang cadangan tentang litar ini boleh hantar kepada saya..
Sekian untuk kali ini...
Wassalam..










Bi-directional DC Motor Speed Control

Penerangan Litar


Projek DC Motor Controller ini boleh mangawal kelajuan motor DC dalam dua arah (Forward / Reverse) menggunakan pulse-width modulation (PWM). 
Jarak kawalan motor ini dari fully OFF to ON dalam kedua-dua arah.
Arah pusingan motor dikawal oleh pot (potentiometer).
Kedudukan tengah pot (potentiometer) adalah OFF